It’s unusually narrow for a heavy-duty manual transmission, making it a great fit for cramped-quarters 4×4, and features small, but adequate horizontal ribbing. In early models, the T18 may be adorned with a T98 casting stamp, even though it’s a.

HAMMERLI INTERNATIONAL 208/211/214/215

Sight Adjustments

Get the best deals on Manual Transmissions & Parts for International Harvester D900 when. Manual Trans Input Shaft Bearing National 208-SL (Fits: International. Designer of rack ovens since 1975 Rotary rack oven G1 1975 1975 The first rotary rack oven was manufactured by BONGARD, the “G1”. It was therefore possible to bake 180 baguettes at a time on one rack, in 24 minutes. 1980 The range was expanded with the launch of the “G5”, a rotary oven model equipped with high-performance heat exchanger hearth with multiple exchangers (Bongard patent.

Clockwise down.
Clockwise right.
1 click = 10mm @ 25m

Trigger Adjustments – Early Models

Trigger Weight

Insert allen key through hole in trigger guard into the trigger adjustment screw.
Turn clockwise to increase trigger weight.

Trigger Stop

Strip pistol as described below.
Loosen locking screw, pull down trigger guard and adjust trigger stop screw (as indicated in photo). Clockwise to decrease back-lash.
Manual recommends back-lash should be no more than two to three tenths of a millimetre.

Trigger Adjustments – Late Models

For 208/211 serial numbered after 40335 or 214/215 after 67589.

Trigger Weight

Turn allen key 1.5mm (#1) clockwise to increase trigger weight.

Hammerli 208 International Manual Transmission

Second Stage Travel (Sear Engagement)

This has been set at the factory and is not recommended to be adjusted. Turn screw (#2) clockwise to increase travel.

First Stage Weight

Takeup weight can be increased by turning allen key 1.5mm (#3) clockwise.

First Stage Travel

Hammerli 208 Review

This can be lengthened by turning small screwdriver (#4) clockwise.

Stripping

Check pistol is unloaded and remove magazine. Leave slide in forward position.
Loosen screw at rear (below rear sight) and remove the complete rear sight assembly by pulling the latter out backwards.

Remove the forward barrel weight by loosening the screw(s) and sliding forward.

Remove the slide thus: Hold the pistol with the right hand, pull the trigger guard fully downwards and push this to the left with the right index finger. Now pull the slide back to the full extent of its travel, lift it up, and let it glide forward so as to leave the barrel freely.
To reassemble, proceed in reverse order.

HAMMERLI INTERNATIONAL 208/211/214/215

Sight Adjustments

Trigger Adjustments – Early Models

Trigger Weight

Trigger Stop

Trigger Adjustments – Late Models

Trigger Weight

Second Stage Travel (Sear Engagement)

First Stage Weight

First Stage Travel

Hammerli 208 Review

Stripping

Hammerli 208 Magazine

Exploded View

Hammerli 208 International Manual Transmission Parts

Owner’s Manual for the 208 & 215 models